How to Fit a Coaxial Cable Connector: F-Type, IEC and BNC
A badly fitted connector is the most common cause of poor TV, satellite and CCTV pictures. This guide shows how to fit the main coaxial connectors properly.
Tools you need
- A coax stripping tool sized for the cable (RG6 or RG59)
- Connectors that match the cable type exactly
- A compression or crimp tool for compression and crimp connectors
- A sharp cutter
How to fit an F-type compression connector
- Cut the cable end square.
- Strip it in two steps: typically about 6 mm of bare centre conductor and a further 6 mm of dielectric with the screen, following the connector maker’s strip lengths.
- Fold the braid back neatly over the jacket and trim any loose strands so none touch the centre conductor.
- Push the connector onto the cable until the dielectric is flush inside the connector.
- Compress the connector with the tool.
- Check that the centre conductor stands about 1 to 2 mm proud of the connector face and that no braid strands are loose.
Connecting a coaxial cable to a TV aerial
Most TV aerial sockets in the UK and Europe take an IEC (Belling-Lee) plug. Fit the plug to the cable as above, push it into the TV or wall plate, and run a channel scan. For satellite boxes and broadband modems use an F-type connector, screwed on finger-tight.
BNC connectors for CCTV
Analogue and HD-over-coax CCTV uses BNC connectors. Use compression BNC connectors matched to RG59 or RG6, and keep the centre pin straight when pushing it onto the camera or recorder.
Common mistakes
- Braid strands touching the centre conductor, which shorts the signal
- A nicked or scored centre conductor
- Twist-on connectors that work loose; compression connectors hold better
- Using connectors made for a different cable size
Read more in what is coaxial cable, or browse RG6 and RG59 coaxial cables.