default

How to Fit a Coaxial Cable Connector: F-Type, IEC and BNC

A badly fitted connector is the most common cause of poor TV, satellite and CCTV pictures. This guide shows how to fit the main coaxial connectors properly.

Tools you need

  • A coax stripping tool sized for the cable (RG6 or RG59)
  • Connectors that match the cable type exactly
  • A compression or crimp tool for compression and crimp connectors
  • A sharp cutter

How to fit an F-type compression connector

  1. Cut the cable end square.
  2. Strip it in two steps: typically about 6 mm of bare centre conductor and a further 6 mm of dielectric with the screen, following the connector maker’s strip lengths.
  3. Fold the braid back neatly over the jacket and trim any loose strands so none touch the centre conductor.
  4. Push the connector onto the cable until the dielectric is flush inside the connector.
  5. Compress the connector with the tool.
  6. Check that the centre conductor stands about 1 to 2 mm proud of the connector face and that no braid strands are loose.

Connecting a coaxial cable to a TV aerial

Most TV aerial sockets in the UK and Europe take an IEC (Belling-Lee) plug. Fit the plug to the cable as above, push it into the TV or wall plate, and run a channel scan. For satellite boxes and broadband modems use an F-type connector, screwed on finger-tight.

BNC connectors for CCTV

Analogue and HD-over-coax CCTV uses BNC connectors. Use compression BNC connectors matched to RG59 or RG6, and keep the centre pin straight when pushing it onto the camera or recorder.

Common mistakes

  • Braid strands touching the centre conductor, which shorts the signal
  • A nicked or scored centre conductor
  • Twist-on connectors that work loose; compression connectors hold better
  • Using connectors made for a different cable size

Read more in what is coaxial cable, or browse RG6 and RG59 coaxial cables.